The optimization of welding parameters for friction stir spot welding of high density polyethylene sheets

• Published in: Materials in engineering 2011-08, Vol.32 (7), p.4074-4079
• Main Authors: Bilici, Mustafa Kemal, Yükler, Ahmet İrfan, Kurtulmuş, Memduh
• Format: Article
• Language: English
• Subjects: Analysis of variance; Friction stir welding; Optimization; Orthogonal arrays; Polyethylenes; Spot welding; Weld strength; Welding parameters
• ISSN: 0261-3069
• DOI: 10.1016/j.matdes.2011.03.014

Three phases of friction stir spot welding process, (a) plunging, (b) stirring and (c) retracting [8] and ANOVA analyses, the optimal welding parameters (dwell time and plunge depth) for weld strength. [Display omitted] ► Friction stir spot welding parameters affect the weld strength of polyethylene sheets. ► A minitab statistical software was used to explain the welding parameter effect. ► Tables, diagrams were drawn to display on the weld strength. ► An application of Taguchi method was obtained optimum welding parameters. Friction stir spot welding parameters affect the weld strength of thermoplastics, such as high density polyethylene (HDPE) sheets. The strength of a friction stir spot weld is usually determined by a lap-shear test. For maximizing the weld strength, the selection of welding parameters is very important. This paper presents an application of Taguchi method to friction stir spot welding strength of HDPE sheets. An orthogonal array, the signal to noise ratio ( S/ N), and the analysis of variance (ANOVA) are employed to investigate friction stir welding parameter effects on the weld strength. From the ANOVA and the S/ N ratio response graphs, the significant parameters and the optimal combination level of welding parameters were obtained. Experimental results confirmed the effectiveness of the method.