Comparison of analog and digital preoperative planning in total hip and knee arthroplasties: A prospective study of 173 hips and 65 total knees

• Published in: Acta orthopaedica 2005-02, Vol.76 (1), p.78-84
• Main Authors: The, Bertram, Diercks, Ron L, van Ooijen, Peter M A, van Horn, Jim R
• Format: Article
• Language: English
• Subjects: Arthroplasty, Replacement, Hip - methods; Arthroplasty, Replacement, Knee - methods; Biological and medical sciences; Hip Prosthesis; Humans; Knee Prosthesis; Medical sciences; Observer Variation; Orthopedic surgery; Patient Care Planning; Preoperative Care - methods; Prospective Studies; Prosthesis Design; Prosthesis Fitting; Radiographic Image Interpretation, Computer-Assisted - methods; Surgery (general aspects). Transplantations, organ and tissue grafts. Graft diseases
• ISSN: 1745-3674; 0001-6470; 1745-3682
• DOI: 10.1080/00016470510030364

Introduction Digital correction of the magnification factor is expected to yield more accurate and reliable preoperative plans. We hypothesized that digital templating would be more accurate than manual templating for total hip and knee arthroplasties. Patients and methods Firstly, we established the interobserver and intraobserver reliability of the templating procedure. The accuracy and reliability of digital and analog plans were measured in a series of 238 interventions, which were all planned using both techniques. Results Interobserver reliability was good for the planning of knee arthroplasties (κ-values 0.63-0.75), but not more than moderate for the planning of hip arthroplasties (κ-values 0.22-0.54). Analog plans of knee arthroplasties systematically underestimated the component sizes (1.1 size on average), while the digital procedure proved to be accurate (0.1-0.4 size too small on average). The following figures show percentage of cases receiving a correct implant, allowing an error of one size. Digital templating of the hip arthroplasty was less frequently correct (cemented cup and stem: 72% and 79%; uncemented cup and stem: 52% and 66%) than analog planning (cemented cup and stem: 73% and 89%; uncemented cup and stem: 64% and 52%). Interpretation Planning of component sizes for total knee arthroplasties is an accurate procedure when performed digitally. Our digital preoperative plans which were performed by someone other than the surgeon were less accurate than the analog plans prepared by the surgeon.