Photocatalytic formation of a gas permeable layer selectively deposited on supported metal nanoparticles for sintering-resistant thermal catalysis

• Published in: Nanoscale advances 2023-02, Vol.5 (4), p.1124-1132
• Main Authors: Takabayashi, Ayato, Kishimoto, Fuminao, Tsuchiya, Hiroto, Mikami, Hitoshi, Takanabe, Kazuhiro
• Format: Article
• Language: English
• Subjects: Chemistry
• ISSN: 2516-0230; 2516-0230
• DOI: 10.1039/d2na00703g

Nanoparticle aggregation of supported metal catalysts at high temperatures is a serious problem that causes a drop in catalytic performance. This study investigates the protection of metal nanoparticles from sintering by selectively forming nanoscale SiO 2 shells on Pd supported on TiO 2 by ultraviolet (UV) light irradiation. The proton-coupled reduction reaction increases the local pH around Pd nanoparticles, resulting in hydrolysis of tetraethoxyorthosilicate (TEOS) in only the vicinity of the metal. An apparent quantum efficiency of only 0.6% is obtained for the Pd/TiO 2 catalyst in H 2 evolution from ethanol-containing water under 370 nm excitation light. Therefore, the pH of raw slurry solution should be precisely controlled to that slightly below the threshold value for the TEOS hydrolysis reaction before the photodeposition. Transmission electron microscopy (TEM) and energy dispersive X-ray spectroscopy (EDX) clearly show that the particle size of the Pd nanoparticles (∼40 nm) with the SiO 2 shell (∼20 nm) was almost unchanged by the high-temperature treatment at 900 °C in air, suggesting that the SiO 2 shell prevented thermal aggregation of Pd nanoparticles. The Pd/TiO 2 without SiO 2 shell decoration exhibited a drop in the number of active sites, which was likely due to aggregation of the Pd catalysts. However, the number of active sites on the Pd@SiO 2 /TiO 2 catalyst was maintained even after the catalyst was calcined at 900 °C. Consequently, the Pd@SiO 2 /TiO 2 catalyst maintained its catalytic performance for simulated exhaust gas purification even after treatment at 900 °C. This study presents a methodology to produce sintering-tolerant supported metal nanoparticles using the photocatalytic gas permeable layer fabrication method. This paper presents a new methodology to produce a sintering-resistant exhaust gas purification catalyst with ultrathin SiO 2 decoration on already supported Pd metal nanoparticles using a vacuum-free photocatalytic layer deposition method.