3D statistical failure analysis of monolithic dental ceramic crowns

• Published in: Journal of biomechanics 2016-07, Vol.49 (10), p.2038-2046
• Main Authors: Nasrin, Sadia, Katsube, Noriko, Seghi, Robert R, Rokhlin, Stanislav I
• Format: Article
• Language: English
• Subjects: Cement; Cements; Ceramic cements; Ceramics; Crowns; Dental Porcelain; Dental Stress Analysis - methods; Dentin; Failure; Failure analysis; Failure probability; Finite element; Finite Element Analysis; Fracture mechanics; Humans; Intellectual property; Interface initiated failures; Interfacial shear stresses; Load; Materials Testing - methods; Mathematical models; Methods; Monolithic crown; Physical Medicine and Rehabilitation; Stress analysis; Stress concentration; Stress state; Stress, Mechanical; Stresses
• ISSN: 0021-9290; 1873-2380
• DOI: 10.1016/j.jbiomech.2016.05.003

Abstract For adhesively retained ceramic crown of various types, it has been clinically observed that the most catastrophic failures initiate from the cement interface as a result of radial crack formation as opposed to Hertzian contact stresses originating on the occlusal surface. In this work, a 3D failure prognosis model is developed for interface initiated failures of monolithic ceramic crowns. The surface flaw distribution parameters determined by biaxial flexural tests on ceramic plates and point-to-point variations of multi-axial stress state at the intaglio surface are obtained by finite element stress analysis. They are combined on the basis of fracture mechanics based statistical failure probability model to predict failure probability of a monolithic crown subjected to single-cycle indentation load. The proposed method is verified by prior 2D axisymmetric model and experimental data. Under conditions where the crowns are completely bonded to the tooth substrate, both high flexural stress and high interfacial shear stress are shown to occur in the wall region where the crown thickness is relatively thin while high interfacial normal tensile stress distribution is observed at the margin region. Significant impact of reduced cement modulus on these stress states is shown. While the analyses are limited to single-cycle load-to-failure tests, high interfacial normal tensile stress or high interfacial shear stress may contribute to degradation of the cement bond between ceramic and dentin. In addition, the crown failure probability is shown to be controlled by high flexural stress concentrations over a small area, and the proposed method might be of some value to detect initial crown design errors.