Structure zone diagram and particle incorporation of nickel brush plated composite coatings

• Published in: Scientific reports 2017-03, Vol.7 (1), p.44561-44561, Article 44561
• Main Authors: Isern, L., Impey, S., Almond, H., Clouser, S. J., Endrino, J. L.
• Format: Article
• Language: English
• Subjects: 639/301/1023/1025; 639/301/930/1032; 639/301/930/12; 639/301/930/543; Aluminum; Coatings; Design; Electroplating; Humanities and Social Sciences; multidisciplinary; Nickel; Science; Sedimentation; Sedimentation & deposition; Velocity
• ISSN: 2045-2322; 2045-2322
• DOI: 10.1038/srep44561

This work studies the deposition of aluminium-incorporated nickel coatings by brush electroplating, focusing on the electroplating setup and processing parameters. The setup was optimised in order to increase the volume of particle incorporation. The optimised design focused on increasing the plating solution flow to avoid sedimentation, and as a result the particle transport experienced a three-fold increase when compared with the traditional setup. The influence of bath load, current density and the brush material used was investigated. Both current density and brush material have a significant impact on the morphology and composition of the coatings. Higher current densities and non-abrasive brushes produce rough, particle-rich samples. Different combinations of these two parameters influence the surface characteristics differently, as illustrated in a Structure Zone Diagram. Finally, surfaces featuring crevices and peaks incorporate between 3.5 and 20 times more particles than smoother coatings. The presence of such features has been quantified using average surface roughness Ra and Abbott-Firestone curves. The combination of optimised setup and rough surface increased the particle content of the composite to 28 at.%.