Characterization of PTFE Film on 316L Stainless Steel Deposited through Spin Coating and Its Anticorrosion Performance in Multi Acidic Mediums

• Published in: Materials 2020-01, Vol.13 (2), p.388
• Main Authors: Akram, Waseem, Farhan Rafique, Amer, Maqsood, Nabeel, Khan, Afzal, Badshah, Saeed, Khan, Rafi Ullah
• Format: Article
• Language: English
• Subjects: Acid resistance; Atomic force microscopes; Atomic force microscopy; Corrosion potential; Corrosion prevention; Corrosion resistance; Corrosion tests; Diamond pyramid hardness tests; Electrochemical corrosion; Electrodes; Heat; High temperature; Hydrochloric acid; Hydrogen chloride; Morphology; Nanocomposites; Nitric acid; Phase transitions; Polytetrafluoroethylene; Protective coatings; Scratch tests; Spin coating; Stainless steel; Stainless steels; Substrates; Surface roughness; Thin films
• ISSN: 1996-1944; 1996-1944
• DOI: 10.3390/ma13020388

Polytetrafluoroethylene (PTFE) was coated on 316L stainless steel (SS) substrate through a spin coating technique to enhance its corrosion resistance properties in hydrochloric acid (HCl) and nitric acid (HNO ) medium. Scanning electron microscopy (SEM) revealed the morphology of the coated and uncoated substrates and showed a uniform and crack-free PTFE coating on 316L SS substrate, while a damaged surface with thick corrosive layers was observed after the electrochemical test on the uncoated sample. However, an increased concentration of HCl and HNO slightly affected the surface morphology by covering the corrosive pits. An atomic force microscope (AFM) showed that the average surface roughness on 316L SS and PTFE coating was 26.3 nm and 24.1 nm, respectively. Energy dispersive x-ray spectroscopy (EDS) was used for the compositional analysis, which confirmed the presence of PTFE coating. The micro Vickers hardness test was used to estimate the hardness of 316L SS and PTFE-coated substrate, while the scratch test was used to study the adhesion properties of PTFE coating on 316L SS. The anticorrosion measurements of 316L SS and PTFE-coated substrates were made in various HCl and HNO solutions by using the electrochemical corrosion test. A comparison of the corrosion performance of PTFE-coated substrate with that of bare 316L SS substrate in HCl medium showed a protection efficiency (PE) of 96.7%, and in the case of HNO medium, the PE was 99.02%, by slightly shifting the corrosion potential of the coated sample towards the anodic direction.