Selective Laser Melting of 18NI-300 Maraging Steel

• Published in: Materials 2020-09, Vol.13 (19), p.4268
• Main Authors: Król, Mariusz, Snopiński, Przemysław, Hajnyš, Jiří, Pagáč, Marek, Łukowiec, Dariusz
• Format: Article
• Language: English
• Subjects: Chemical precipitation; Dilatometry; Energy; Flux density; Grain size; Heat; Intermetallic compounds; Laser beam melting; Lasers; Manufacturing; Maraging steels; Martensite; Martensitic transformations; Mechanical properties; Microstructure; Nickel; Porosity; Process parameters; R&D; Research & development; Reversion; Rockwell hardness; Tensile strength; Thickness
• ISSN: 1996-1944; 1996-1944
• DOI: 10.3390/ma13194268

In the present study, 18% Ni 300 maraging steel powder was processed using a selective laser melting (SLM) technique to study porosity variations, microstructure, and hardness using various process conditions, while maintaining a constant level of energy density. Nowadays, there is wide range of utilization of metal technologies and its products can obtain high relative density. A dilatometry study revealed that, through heating cycles, two solid-state effects took place, i.e., precipitation of intermetallic compounds and the reversion of martensite to austenite. During the cooling process, one reaction took place (i.e., martensitic transformation), which was confirmed by microstructure observation. The improvements in the Rockwell hardness of the analyzed material from 42 ± 2 to 52 ± 0.5 HRC was improved as a result of aging treatment at 480 °C for 5 h. The results revealed that the relative density increased using laser speed (340 mm/s), layer thickness (30 µm), and hatch distance (120 µm). Relative density was found approximately 99.3%. Knowledge about the influence of individual parameters in the SLM process on porosity will enable potential manufacturers to produce high quality components with desired properties.