Proper Blends of Biodegradable Polycaprolactone and Natural Rubber for 3D Printing

• Published in: Polymers 2020-10, Vol.12 (10), p.2416
• Main Authors: Wissamitanan, Thossapit, Dechwayukul, Charoenyutr, Kalkornsurapranee, Ekwipoo, Thongruang, Wiriya
• Format: Article
• Language: English
• Subjects: 3-D printers; Biodegradability; Compression tests; Compressive strength; Deposition; Differential scanning calorimetry; Elongation; Enthalpy; Flow velocity; Fused deposition modeling; Hardness; Mechanical properties; Melt flow index; Melt temperature; Melting; Miscibility; Morphology; Natural rubber; Optimization; Plastics; Polycaprolactone; Polyethylene terephthalate; Polymer blends; Rapid prototyping; Rubber; Solid phases; Temperature; Tensile properties; Tensile strength; Thermoplastic elastomers; Three dimensional printing; Zinc oxides
• ISSN: 2073-4360; 2073-4360
• DOI: 10.3390/polym12102416

Flexible thermoplastic elastomers (TPE) were prepared for fused deposition modeling (FDM) or 3D printing. These materials can be used for medical purposes such as disposable soft splints and other flexible devices. Blends of 50% epoxidized natural rubber (ENR-50) and block rubber (Standard Thai Rubber 5L (STR5L)) with polycaprolactone (PCL) were produced and compared. The purpose of this study was to investigate the properties of natural rubber (NR) and PCL in simple blends with PCL contents of 40%, 50%, and 60% by weight (except at 75% for morphology study) in the base mixture (NR/PCL). The significant flow factors for FDM materials, such as melting temperature (Tm) and melt flow rate (MFR), were observed by differential scanning calorimetry (DSC) and via the melt flow index (MFI). In addition, the following mechanical properties were also determined: tensile strength, compression set, and hardness. The results from DSC showed that the melting temperature changed slightly (1–2 °C) with amount of PCL used, and there was a suspicious point in the 50/50 blends with both types of rubber. The lowest melting enthalpy of both blends was found at the 50/50 blended composition. The MFI results showed that PCL significantly affected the melt flow rate of both blends. The ENR-50/PCL blend flowed better than the STR5L/PCL blend. The conclusion was that this was due to the morphology of its phase structure having better uniformity than that of the STR5L/PCL blend. In compression set testing or measuring shape recovery, rubber directly influenced the recovery in all blends. The ENR-50/PCL blend had less recovery than the STR5L/PCL blend, probably due to the functional effects of epoxide groups and polarity mismatch. The hard phase PCL significantly affected the hardness of samples but improved shape recovery of the material. The ENR-50/PCL blend had better tensile properties than the STR5L/PCL blend. The elongation at break of both blends improved with a high rubber content. Hence, the ENR-50/PCL blend was superior to STR5L/PCL for printing purposes due to its better miscibility, uniformity, and flow, which are the keys to success for optimizing the fused deposition modeling conditions as well as the overall mechanical properties of products. Most blends in this study were only slightly different, but the 50/50 blend of ENR-50/PCL seemed to be near optimal for 3D printing.