Screw loosening of different UCLA-type abutments after mechanical cycling

• Published in: Brazilian journal of oral sciences 2013-09, Vol.12 (3), p.228-232
• Main Authors: Junqueira, Marcela C., Ribeiro, Ricardo F., Faria, Adriana Claudia L., Macedo, Ana Paula, Almeida, Rossana P.
• Format: Article
• Language: English
• Subjects: DENTISTRY, ORAL SURGERY & MEDICINE
• ISSN: 1677-3225; 1677-3225
• DOI: 10.1590/S1677-32252013000300014

AIM: To evaluate the loss of applied torque (detorque) values in cast and pre-machined abutments for external hex abutment/implant interface of single implant-supported prostheses subjected to mechanical cycling. METHODS: Ten metal crowns were fabricated using two types of UCLA abutments: cast and pre-machined with metal base in NiCrTi alloy and tightened to regular external hex implants with a titanium alloy screw, with an insertion torque of 32 N.cm, measured with a digital torque gauge. Samples were embedded with autopolymerizing acrylic resin in a stainless steel cylindrical matrix, and positioned in an electromechanical machine. Dynamic oblique loading of 120 N was applied during 5 x 10(5) cycles. Then, each sample was removed from the resin and detorque values were measured using the same digital torque gauge. The difference of the initial (torque) and final (detorque) measurement was registered and the results were expressed as percentage of initial torque. The results of torque loss were expressed as percentage of the initial torque and subjected to statistical analysis by the Student's t-test (p