Combined effect of the interlayer temperature with travel speed on features of thin wall WAAM under two cooling approaches

• Published in: International journal of advanced manufacturing technology 2023-05, Vol.126 (1-2), p.273-289
• Main Authors: Teixeira, Felipe Ribeiro, Scotti, Fernando Matos, Jorge, Vinicius Lemes, Scotti, Américo
• Format: Article
• Language: English
• Subjects: Arc deposition; CAE) and Design; Computer-Aided Engineering (CAD; Cooling; Design of experiments; Engineering; Industrial and Production Engineering; Interlayers; Low alloy steels; Mechanical Engineering; Media Management; Metallurgy; Microstructure; Original Article; Production Technology; Produktionsteknik; Thin walls; Wire
• ISSN: 0268-3768; 1433-3015; 1433-3015
• DOI: 10.1007/s00170-023-11105-w

This work presents the evaluation of the interlayer temperature (IT) with travel speed (TS) combined effect for a given wire feed speed (WFS) on operational, geometrical, and metallurgical features of thin walls with the same width deposited by wire arc additive manufacturing (WAAM) with a low alloy steel, using or not active cooling. A preliminary experimental design was carried out to define a range of IT that could prevent the molten pool from running down and, then, be used in the main experimental design. The main tests were planned and performed to find different IT and TS combinations for a given WFS capable of depositing walls with the same target effective wall width. After selecting the parameters, six walls were deposited, three under natural cooling (NC) and three under near immersion active cooling (NIAC). A more significant temperature variability along the layer length (ΔT/ΔLL) is observed in increasing IT-TS combination and under NIAC. Regardless of the cooling approach, a worse surface aspect was observed with lower IT and TS. However, NC or NIAC do not affect the wall width (effective or external) or the layer height. On the other hand, they are affected by the IT with TS combination. A shorter production time was obtained on the walls with NIAC and higher IT-TS. No marked microstructural differences were observed comparing the walls, regardless of the cooling approach. However, microstructure tempering (hardness reduction) was observed in the walls deposited with NC using higher IT levels.