Investigation of rheo-diecasting mold filling of semi-solid A380 aluminum alloy slurry

• Published in: International journal of minerals, metallurgy and materials metallurgy and materials, 2017-06, Vol.24 (6), p.691-700
• Main Authors: Liu, Zhi-yong, Mao, Wei-min, Wang, Wei-pan, Zheng, Zhi-kai, Yue, Rui
• Format: Article
• Language: English
• Subjects: Alloys; Aluminum; Aluminum alloys; Aluminum base alloys; Ceramics; Characterization and Evaluation of Materials; Chemistry and Materials Science; Composites; Corrosion and Coatings; Die casting; Glass; Grain size; Heat; Investigations; Materials Science; Metallic Materials; Microstructure; Molds; Natural Materials; Particle size; Process parameters; Semisolids; Shape factor; Simulation; Slurries; Solids; Surfaces and Interfaces; Temperature; Thin Films; Tribology; Velocity; Viscosity
• ISSN: 1674-4799; 1869-103X
• DOI: 10.1007/s12613-017-1452-z

The rheo-diecasting mold filling capacity and the microstructure of the semi-solid A380 aluminum alloy slurry were investigated. The results show that the mold filling capacity was strengthened with increasing pouring temperature or increasing injection pressure. Under certain process parameters, the mold cavity was fully filled. However, the mold filling capacity decreased with increasing holding time. The mold filling capacity was improved with increasing shape factor of primary α(Al) grains; however, the solid fraction and the grain size significantly increased at the same time. In addition, the microstructures along the route of the spiral samples obviously differed. The grain size decreased gradually from the near-end to the far-end, whereas the shape factor increased gradually.