Microstructure evolution and mechanical properties of Ti2AlNb/TiAl brazed joint using newly-developed Ti–Ni–Nb–Zr filler alloy

• Published in: Progress in natural science 2020-06, Vol.30 (3), p.410-416
• Main Authors: Ren, Xinyu, Ren, Haishui, Shang, Yonglai, Xiong, Huaping, Zhang, Kai, Zheng, Jinghua, Liu, Dong, Lin, Jianguo, Jiang, Jun
• Format: Article
• Language: English
• Subjects: Brazing; EBSD; Microstructure evolution; Nano-indentation; Ti2AlNb; TiAl
• ISSN: 1002-0071
• DOI: 10.1016/j.pnsc.2020.02.007

Joining of Ti2AlNb alloy to TiAl intermetallics was conducted by the newly-developed Ti–Ni–Nb–Zr brazing filler alloy. The microstructure evolution of the joints was investigated by scanning electron microscope (SEM), energy dispersive spectrometer (EDS) and electron backscatter diffraction (EBSD). The macro-micro mechanical properties were studied by shear test and nano-indentation test. Typical interfacial microstructures across the brazing seam were Ti2AlNb substrate, α2-Ti3Al+β-Ti, γ-TiAl+Ti2Ni+TiNi+α2-Ti3Al, α2-Ti3Al+β-Ti, TiAl substrate. The Ti2Ni phase were firstly dissolved in the joints brazed at 1000 °C for 10 min and then precipitated after a prolonged holding time of 15 min. The nano-indentation test revealed that Ti2Ni phase exhibited the highest hardness of 12.60 GPa. The joints brazed at 1000 °C/15 min presented the maximum shear strength of 271 MPa. The dissolution and precipitation behavior of Ti2Ni phase was also discussed. [Display omitted] •The Ti–Ni–Nb–Zr filler alloy was newly developed and the brazing temperature was decreased to 1000 °C.•The dissolution and precipitation phenomenon of Ti2Ni phase was explained by dynamic equilibrium reaction.•The joints brazed at 1000 °C/15 min presented the maximum shear strength of 271 MPa.