Search Results - Bleed, D*
-
1
-
2
-
3
Aerodynamic influence of a bleed on the last stage of a low-pressure compressor and S-duct
Published 2021“…For bleeds up to 20%, the S-duct displayed a remarkable resilience and consistency of flow variables at duct exit. …”
Get full text
Default Article -
4
Development of machine vision techniques for intraoperative registration and bleeding characterisation in robot-assisted neurosurgery
Published 2009“…Development of machine vision techniques for intraoperative registration and bleeding characterisation in robot-assisted neurosurgery…”
Get full text
Default Thesis -
5
Experimental investigation of the effect of bleed on the aerodynamics of a low-pressure compressor stage in a turbofan engine [GT2023-102260]
Published 2023Subjects: Get full text
Default Conference proceeding -
6
Experimental investigation of the effect of bleed on the aerodynamics of a low-pressure compressor stage in a turbofan engine
Published 2023Subjects: Get full text
Default Article -
7
Novel methods of drag reduction for squareback road vehicles
Published 2013Subjects: Get full text
Default Thesis -
8
"Gushing Out Blood": Defloration and menstruation in Memoirs of a Woman of Pleasure
Published 2016Subjects: Get full text
Default Article -
9
Epoxy adhesive behaviour on ceramic surfaces in commercial optoelectronic assemblies
Published 2010Get full text
Default Article -
10
Empowering women through sanitation activities
Published 2003Get full text
Default Conference proceeding -
11
Experimental and computational study of hybrid diffusers for gas turbine combustors
Published 2002“…A hybrid diffuser demonstrated a 53% increase in area ratio within the same axial length as the conventional diffuser. …”
Get full text
Default Thesis -
12
Experimental and computational study of hybrid diffusers for gas turbine combustors
Published 2003“…Conventional diffuser systems have a finite limit to the diffusion that can be achieved in a given length and it is, therefore, necessary for designers to consider more radical and unconventional diffuser configurations. …”
Get full text
Default Conference proceeding -
13
Experimental and computational study of hybrid diffusers for gas turbine combustors
Published 2004“…The increasing radial depth of modern combustors poses a particularly difficult aerodynamic challenge for the pre-diffuser. …”
Get full text
Default Article -
14
Evaluating environmental control system thermal response to degraded operating conditions
Published 2016“…The full range of degradation in each fault is considered, allowing the quantification of overall system performance degradation. …”
Get full text
Default Conference proceeding -
15
Aerodynamic drag reduction on a simple car-like shape with rear upper body taper
Published 2013“…The effects of taper angle and taper length on drag and lift characteristics are investigated. It is shown that a significant drag reduction can be obtained with moderate taper angles. …”
Get full text
Default Article -
16
Development of a full scale experimental and simulation tool for environmental control system optimisation and fault detection
Published 2015“…The facility allows the ECS to be run at conditions similar to those in the aircraft during ground operation. Data from the rig is presented and used to validate a 1-D thermodynamic model. …”
Get full text
Default Conference proceeding -
17
Efficient and safe correction of hemophilia A by lentiviral vector-transduced BOECs in an implantable device
Published 2021“…Hemophilia A (HA) is a rare bleeding disorder caused by deficiency/dysfunction of the FVIII protein. …”
Get full text
Default Article -
18
Haematoma detection using EIT in a sheep model
Published 2014“…Performance evaluation of a portable digital electrical impedance tomography system to detect haematomas using phantom and sheep models is presented. …”
Get full text
Default Article -
19
Acceptability and utilisation of patient‐initiated follow‐up for endometrial cancer amongst women from diverse ethnic and social backgrounds: A mixed methods study
Published 2019“…Forty-five women contacted the CNS at least once (19.7%) with the primary reason being vaginal bleeding/discharge (42%). Contact was greater in first six months of entering the scheme as compared to the second six months and women who made contact were significantly younger than those who did not (57 years versus 65 years, p…”
Get full text
Default Article -
20
Development of combi-pills using the coupling of semi-solid syringe extrusion 3D printing with fused deposition modelling
Published 2022“…Three-dimensional (3D) printing allows for the design and printing of more complex designs than traditional manufacturing processes. …”
Get full text
Default Article -
21
Periodontal diseases in elderly in Indonesia and the risk factors
Published 2020“…Conclusion: Regardless of the model used (logistic or linear regression), a high dental plaque score emerged as a main and independent determinant of periodontal disease. …”
Get full text
Default Article -
22
The rheological performance of wet-process sprayed mortars
Published 1999“…The two-point apparatus was successful with low-workability mortars and their flow resistance and torque viscosities were determined. These parameters were also obtained with the Viskomat, although problems were encountered due to their low workability. …”
Get full text
Default Article -
23
An evaluation of repair mortars installed by worm-pump spraying
Published 2001“…The mortars were pumped and sprayed with a small diameter worm pump and the build thickness determined. …”
Get full text
Default Conference proceeding -
24
-
25
'Those Sweet and Benign Humours that Nature Sends Monthly': accounting for menstruation in early-modern England
Published 2010“…Like all occasions of bleeding, pregnancy and lochial bleeding was seen as a dangerous event. …”
Get full text
Default Thesis -
26
A machine learning approach to tracking and characterizing planar or near planar fluid flow from motion history images
Published 2019“…Based on its importance in assessing injuries in general and from a medical perspective in directing the course of surgery, fluid flow assessment is deemed to be a desirable addition to a surgical robot’s capabilities. …”
Get full text
Default Conference proceeding -
27
A portable EIT system for emergency medical care
Published 2016“…A growing haematoma can cause severe and even permanent damage to the delicate tissue of the brain, morbidity, and eventual death of the patient. …”
Get full text
Default Thesis -
28
Impact of a cooled cooling air installation on the external aerodynamics of a gas turbine combustion system
Published 2015“…A so-called hybrid diffuser was designed in which the CCA bleed was moved to the pre-diffuser outer wall. …”
Get full text
Default Conference proceeding -
29
Behaviour of radionuclides in the presence of superplasticiser
Published 2013“…Digital autoradiography reveals heterogeneous distribution of radioactivity in the monoliths and demonstrates that the dissolved metals have not been effectively immobilised throughout the specimen. …”
Get full text
Default Article -
30
A machine learning approach to tracking and characterizing planar or near planar fluid flow
Published 2021“…Based on its importance in assessing injuries and from a medical perspective in directing the course of surgery, fluid flow assessment is deemed to be a desirable addition to a surgical robot's capabilities. …”
Get full text
Default Article -
31
Knowledge of the risk factors and symptons associated with endometrial cancer in British South Asian and British white women
Published 2018“…Study design: Face-to-face, semi-structured interviews exploring knowledge; diagnosis; treatment; follow-up; and survivorship were undertaken and analysed using Thematic Analysis. …”
Get full text
Default Article -
32
The stability of cement superplasticiser and its effect on radionuclide behaviour
Published 2012“…Under chemical (alkali) attack by exposure to 0.1 mol dm-3 NaOH and 95% saturated Ca(OH)2 , the superplasticiser samples were found to decrease in molecular weight, a result consistent with alkaline hydrolysis of the polymer chains. …”
Get full text
Default Thesis -
33
LDA measurements of feed annulus effects on combustor liner port flows
Published 2001“…The data are relevant to primary and dilution jet flows as found in gas-turbine combustor liners. …”
Get full text
Default Article -
34
Component-led integrative optimisation methodology for avionic thermal management
Published 2017“…As the on-board subsystems have become more complex and diverse, the development process has become more isolated. …”
Get full text
Default Thesis -
35
Thermal sensitivity analysis of avionic and environmental control subsystems to variations in flight condition
Published 2016“…The highest system efficiency is delivered at high altitude low load cruise conditions, with the lowest efficiency found at high speed low attitude flight. …”
Get full text
Default Conference proceeding -
36
A study into refrigeration cycle working fluids using an air cycle machine environmental control system
Published 2016“…The difficulties of accurately modelling these behaviours is discussed and demonstrated to validate the experimental methodology utilised in this paper. …”
Get full text
Default Conference proceeding -
37
Investigations relating to factors influencing the effectiveness of an aero-engine intake thermal anti-icing system
Published 1991“…This thesis describes the experimental work and compares the results with the Computational Fluid Dynamics predictions. …”
Get full text
Default Thesis -
38
Advanced electronic interconnections based on template-assisted electrodeposited Cu nanowire/micropillar arrays
Published 2022“…In line with demands of three-dimensional integrated circuit (3D IC), the uses of purposely designed Cu-Sn NI are made in the experiments to accelerate the transient liquid phase bonding (TLPB) process, which is extremely slow based on conventional bonding process. …”
Get full text
Default Thesis