Reaction rate and MWD changes in crosslinking of PVC, with dithioltriazine

• Published in: Journal of applied polymer science 1989-02, Vol.37 (5), p.1239-1251
• Main Authors: Hjertberg, Thomas, Dahl, Roger, Sörvik, Erling
• Format: Article
• Language: English
• Subjects: Applied sciences; Chemical reactions and properties; Crosslinking, vulcanization; Exact sciences and technology; Organic polymers; Physicochemistry of polymers
• ISSN: 0021-8995; 1097-4628
• DOI: 10.1002/app.1989.070370508

The reaction rate of crosslinking of PVC with dithioltriazine has been studied by following gel formation and changes in the molecular weight distribution (MWD). Compounding was performed on a roll mill at 145°C and crosslinking by heat treatment at 180 or 90°C. In this system crosslinking is executed by the thiolate anion, formed in situ by reaction with MgO. We have studied the catalyzing effect of several polyols in order to achieve a more efficient reaction. Most likely, these catalysts work by chelating the Mg2+ ions, thus increasing the nucleophilic character of the thiolate. With the most efficient ones, ditrimethylolpropane and HO(CH2CH2)6‐7H, complete crosslinking can be obtained in 3 min at 180°C, i.e., at processing temperatures. We also followed the changes in the MWD before gelation at a considerably lower temperature, 145°C, and found an extensive molecular enlargement even after 5‐10 min. Most surprisingly, μMn increased up to 100% without formation of insoluble material. By 1H‐NMR measurements on low molecular weight extracts, we have shown this to be due to a fast and selective reaction with allylic chlorine in the unsaturated end groups, ∼ CH2CHCHCH2Cl, formed in the mechanism of chain transfer to monomer. Due to this reaction, formulations with too high reactivity may crosslink during processing, which calls for a careful balancing of the reactivity for each processing case.