Effects of surface mechanical attrition treatment (SMAT) on a rough surface of AISI 316L stainless steel

• Published in: Applied surface science 2012-03, Vol.258 (10), p.4538-4543
• Main Authors: Arifvianto, B., Suyitno, Mahardika, M.
• Format: Article
• Language: English
• Subjects: AISI 316L; Condensed matter: electronic structure, electrical, magnetic, and optical properties; Condensed matter: structure, mechanical and thermal properties; Cross-disciplinary physics: materials science; rheology; Exact sciences and technology; Morphology; Physics; Roughness; SMAT; Surface
• ISSN: 0169-4332; 1873-5584
• DOI: 10.1016/j.apsusc.2012.01.021

► A roughness decreasing phenomenon during the SMAT is observed. ► Stages in surface smoothening by the SMAT: (1) rapid reduction, (2) saturation roughness. ► Indentation and material removal by the impact of milling balls are the two principal mechanisms. ► A smoother surface and larger mass reduction are yielded by the SMAT with bigger milling balls. ► The initial surface roughness does not influence the work hardening by the SMAT. Surface mechanical attrition treatment (SMAT) improves mechanical properties of metallic materials through the formation of nanocrystallites at their surface layer. It also modifies the morphology and roughness of the work surface. Surface roughening by the SMAT has been reported previously in a smooth specimen, however in this study the starting point was a rough surface and a smoothening phenomenon is observed. In this paper, the mechanisms involved in the surface smoothening of AISI 316L stainless steel during the SMAT are elucidated. The SMAT was conducted on a specimen with a roughness of Ra=3.98μm for 0–20min. The size of milling balls used in the SMAT was varied from 3.18mm to 6.35mm. The modification of subsurface microhardness, surface morphology, roughness and mass reduction of the specimen due to the SMAT were studied. The result shows the increasing microhardness of the surface and subsurface of the steel due to the SMAT. The impacts of milling balls deform the surface and produce a flat-like structure at this layer. Surface roughness decreases until its saturation is achieved in the SMAT. The mass reduction of the specimens is also detected and may indicate material removal or surface erosion by the SMAT. The size of milling ball is found to be the important feature determining the pattern of roughness evolution and material removal during the SMAT. From this study, two principal mechanisms in the evolution of surface morphology and roughness during the SMAT are proposed, i.e. indentation and surface erosion by the multiple impacts of milling balls. A comparative study with the results of the previous experiment indicates that the initial surface roughness has no influence in the work hardening by the SMAT but it does slightly on the saturated roughness value obtained by this treatment.