Fabrication of alumina ceramics with functional gradient structures by digital light processing 3D printing technology

• Published in: Ceramics international 2022-04, Vol.48 (8), p.10613-10619
• Main Authors: Zeng, Yong, Sun, Lijun, Yao, Haihua, Chen, Jimin
• Format: Article
• Language: English
• Subjects: 3D printing; Alumina; Energy absorption; Functional gradient structure; Mechanical properties
• ISSN: 0272-8842; 1873-3956
• DOI: 10.1016/j.ceramint.2021.12.275

Alumina ceramics with different unit numbers and gradient modes were prepared by digital light processing (DLP) 3D printing technology. The side length of each functional gradient structure was 10 mm, the porosity ratio was controlled to 70%, and the number of units were (1 × 1 × 1 unit) and (2 × 2 × 2 unit) respectively. The different gradient modes were named FCC, GFCC-1, GFCC-2 and GFCC-3. SEM, XRD, and other characterization methods proved that these gradient structures of alumina ceramics had only α-Al2O3 phase and good surface morphology. The mechanical properties and energy absorption properties of alumina ceramics with different functional gradient structures were studied by compression test. The results show that the gradient structure with 1 × 1 × 1 unit has better mechanical properties and energy absorption properties when the number of units is different. When the number of units is the same, GFCC-2 and GFCC-3 gradient structures have better compressive performance and energy absorption potential than FCC structures. The GFCC-2 gradient structure with 1 × 1 × 1 unit has a maximum compressive strength of 19.62 MPa and a maximum energy absorption value of 2.72 × 105 J/m3. The good performance of such functional gradient structures can provide new ideas for the design of lightweight and compressive energy absorption structures in the future.