Spectral density analysis of the interface in stratified oil–water flows

• Published in: International journal of multiphase flow 2014-10, Vol.65, p.117-126
• Main Authors: Barral, A.H., Angeli, P.
• Format: Article
• Language: English
• Subjects: Conductance probe; Exact sciences and technology; FFT; Fluid dynamics; Fundamental areas of phenomenology (including applications); Instrumentation for fluid dynamics; Multiphase and particle-laden flows; Nonhomogeneous flows; Physics; Power spectrum; Stratified oil–water flow
• ISSN: 0301-9322; 1879-3533
• DOI: 10.1016/j.ijmultiphaseflow.2014.06.005

•Complete methodology to estimate power spectra of stratified oil–water interface.•Wiener–Khinchine theorem application and use of Fast Fourier Transform algorithm.•Interface spectra reveal frequency (19Hz) related to waves seen at inlet.•The 19Hz peak is independent of the flow conditions. In this work the wavy interface of stratified oil–water flows was investigated using wire conductance probes. The experiments were carried out in a 38mm ID acrylic pipe using water and oil (Exxsol D140 oil: ρo=830kgm−3, μo=0.0055kgm−1s−1) as test fluids. High-speed imaging revealed that almost two-dimensional interfacial waves develop at the inlet junction for input oil-to-water flow rate ratios different from one. Downstream the inlet section, however, the interface has a complex three dimensional structure with very small amplitude contributions. The structure of such interfaces can be properly investigated from the power spectrum of the conductance probe signal. A rigorous and detailed methodology is presented for estimating the power spectrum of the interface signal that is based on the Wiener–Khinchine theorem and makes extensive use of a Fast Fourier Transform (FFT) algorithm. Interface spectra were studied at two locations, close to the inlet of the test section and at 7m downstream. The results showed that the waves at the inlet have a unique peak frequency of about 19Hz and that, at the downstream location, this frequency is still present but has a smaller significance compared to that caused by the mechanical vibrations of the set up. This frequency was independent of the flow rates and could be a characteristic of the pair of the test fluids used rather than of the flow.