Use of ion beams to simulate reaction of reactor fuels with their cladding

• Published in: Nuclear instruments & methods in physics research. Section B, Beam interactions with materials and atoms Beam interactions with materials and atoms, 2006-01, Vol.242 (1-2), p.487-489
• Main Authors: Birtcher, R.C., Baldo, P.
• Format: Article
• Language: English
• Subjects: Diffusion; Irradiation-induced diffusion; Low enrichment; Reactor fuel
• ISSN: 0168-583X; 1872-9584
• DOI: 10.1016/j.nimb.2005.08.174

Processes occurring within reactor cores are not amenable to direct experimental observation. Among major concerns are damage, fission gas accumulation and reaction between the fuel and its cladding all of which lead to swelling. These questions can be investigated through simulation with ion beams. As an example, we discuss the irradiation driven interaction of uranium–molybdenum alloys, intended for use as low-enrichment reactor fuels, with aluminum, which is used as fuel cladding. Uranium–molybdenum coated with a 100nm thin film of aluminum was irradiated with 3MeV Kr ions to simulate fission fragment damage. Mixing and diffusion of aluminum was followed as a function of irradiation with RBS and nuclear reaction analysis using the 27Al(p,γ)28Si reaction which occurs at a proton energy of 991.9keV. During irradiation at 150°C, aluminum diffused into the uranium alloy at a irradiation driven diffusion rate of 30nm2/dpa. At a dose of 90dpa, uranium diffusion into the aluminum layer resulted in formation of an aluminide phase at the initial interface. The thickness of this phase grew until it consumed the aluminum layer. The rapid diffusion of Al into these reactor fuels may offer explanation of the observation that porosity is not observed in the fuel particles but on their periphery.