Sensitivity analysis of mass transfer and enhancement factor correlations for the absorption of CO2 in a Sulzer DX packed column using 4-diethylamino-2-butanol (DEAB) solution

• Published in: Separation and purification technology 2021-08, Vol.268, p.118696, Article 118696
• Main Authors: Pakzad, Peyman, Mofarahi, Masoud, Lee, Chang-Ha
• Format: Article
• Language: English
• Subjects: CO2 capture; Packed column; Rate-based model; Sensitivity analysis; Sulzer DX
• ISSN: 1383-5866; 1873-3794
• DOI: 10.1016/j.seppur.2021.118696

[Display omitted] •Rate-based model was developed for CO2 capture in a Sulzer DX column using DEAB.•Deshmukh-Mather model was used to calculate CO2 concentration at high CO2 loading.•Sensitivity analysis was conducted on mass transfer, interfacial area, and E models.•Effects of CO2 loading and liquid temperature and flow rate were studied on E value. In this study, a rate-based model of post-combustion CO2 capture was developed for an absorption column packed with Sulzer DX. A new amine solution, 4-diethylamino-2-butanol (DEAB), was applied to the absorber as an active CO2 capture solvent, and a sensitivity analysis on mass-transfer coefficients in liquid and gas phases (kL and kG), effective interfacial area (ae), and enhancement factor (E) correlations was conducted to enhance the performance of the absorber. In the modeling, the absorber was divided into two sections—low capacity (less than 0.5 mol CO2/mol DEAB) and high capacity (more than 0.5 mol CO2/mol DEAB)—to improve model prediction accuracy, especially at high CO2 loading (αCO2). At αCO2 of less than 0.5, the CO2 equilibrium molar concentration (CCO2,e) was neglected, while at higher αCO2, the Deshmukh–Mather activity coefficient model was used to calculate CCO2,e. The solution procedure was validated against the axial experimental data of the CO2 mole fraction in the gas phase (yCO2) and the liquid-phase temperature (TL). Then, a sensitivity analysis was performed for the profiles of αCO2, yCO2, H2O mole fraction in the gas phase (yH2O), TL, and gas-phase temperature (TG) through various mass-transfer correlations for the Sulzer DX packing. The rate-based model with kL, kG and ae found that the correlation coefficient (R2) and average absolute relative deviation (AARD%) of yCO2 data were 0.9889 and 3.12, and those of TL data were 0.9685 and 2.09. The sensitivity analysis of various E correlations also revealed no significant difference between the calculated E values using the different relationships. Finally, the effects of αCO2, TL, and liquid flow rate (L) as the most important parameters of the absorber on the E value were investigated. The results indicated that αCO2 has a significant impact on the E values and consequently on the reaction rate.