Eddy covariance flux measurements of ammonia by high temperature chemical ionisation mass spectrometry

• Published in: Atmospheric measurement techniques 2011-03, Vol.4 (3), p.599-616
• Main Authors: Sintermann, J., Spirig, C., Jordan, A., Kuhn, U., Ammann, C., Neftel, A.
• Format: Article
• Language: English
• ISSN: 1867-8548; 1867-1381; 1867-8548
• DOI: 10.5194/amt-4-599-2011

A system for fast ammonia (NH3) measurements with chemical ionisation mass spectrometry (CIMS) based on a commercial Proton Transfer Reaction-Mass Spectrometer (PTR-MS) is presented. It uses electron transfer reaction as ionisation pathway and features a drift tube of polyetheretherketone (PEEK) and silica-coated steel. Heating the instrumental inlet and the drift tube to 180 °C enabled an effective time resolution of ~1 s and made it possible to apply the instrument for eddy covariance (EC) measurements. EC fluxes of NH3 were measured over two agricultural fields in Oensingen, Switzerland, following fertilisations with cattle slurry. Air was aspirated close to a sonic anemometer at a flow of 100 STP L min−1 and was directed through a 23 m long 1/2" PFA tube heated to 150 °C to an air-conditioned trailer where the gas was sub-sampled from the large bypass stream. This setup minimised damping of fast NH3 concentration changes between the sampling point and the actual measurement. High-frequency attenuation loss of the NH3 fluxes of 20 to 40% was quantified and corrected for using an empirical ogive method. The instrumental NH3 background signal showed a minor interference with H2O which was characterised in the laboratory. The resulting correction of the NH3 flux after slurry spreading was less than 1‰. The flux detection limit of the EC system was about 5 ng m−2 s−1 while the accuracy of individual flux measurements was estimated 16% for the high-flux regime during these experiments. The NH3 emissions after broad spreading of the slurry showed an initial maximum of 150 μg m−2 s−1 with a fast decline in the following hours.