Influence of the Sphero-Cylindrical Tool Orientation Angles on Roughness under Processing Complex-Profile Surfaces

• Published in: Advanced engineering research (Rostov-na-Donu, Russia) Russia), 2023-09, Vol.23 (3), p.231-240
• Main Authors: Gimadeev, M. R., Nikitenko, A. V., Berkun, V. O.
• Format: Article
• Language: eng ; rus
• Subjects: amplitude roughness parameter; milling of complex-profile surfaces; orientation of a sphero-cylindrical tool; spatially complex surfaces
• ISSN: 2687-1653; 2687-1653
• DOI: 10.23947/2687-1653-2023-23-3-231-240

Introduction. When milling complex-profile surfaces of parts, the selection of tool trajectories and orientations affect the roughness parameters. However, in the studies devoted to the formation of trajectories, recommendations to provide the quality of microgeometry of surfaces were not taken into account. Moreover, when writing programs for CNC equipment in CAM systems, the limitations of cutting modes were determined exclusively using a geometric approach. It did not take into account the influence of the orientation angles of the sphero-cylindrical tool relative to the normal plane on the quality of surface treatment, namely on roughness. The work was aimed at the creation of the methodology for selecting the limiting values of the orientation angles of a sphero-cylindrical tool to optimize the process of machining spatially complex surfaces.  The  tasks  included  achieving  the  minimum  values  of  the  amplitude  roughness  parameter  Rz and determining the effectiveness of various machining paths. Materials and Methods .  Methods  of  correlation  and  regression  analysis  were  used,  the  results  were  compared  and generalized. The least-squares method was applied to estimate the parameters of the regression equation. The DMU 50 ecoline  processing  center  was  used  for  the experimental  studies.  Roughness  was  measured  on  a  Surfcam  1800  D profilometer. The material of the samples was steel 12X18N10T. The material of the tool was hard alloy 1620 Sandvik with PVD coating (physical vapor deposition, the closest domestic analogue is T15K6). Results . It has been shown in detail how roughness parameters Rz depend on the angle of inclination and the diameter of the tool. Twenty examples were summarized in a table. Natural regression coefficients were calculated using linear and hyperbolic models. It was found that the diameter of the tool had a greater effect on the formation of roughness parameter Rz than the angle of inclination. For a detailed description of the influence features, the coefficients of multiple, partial, paired correlation and multiple determination were compared. The limitations associated with the angles of inclination of the  tool  when  processing  complex  surfaces  were  determined.  A  scheme  for  calculating  the  angle  of  the  normal  was visualized, which included the selected step along the axis to determine the lengths of the segments of the broken curve. The profilograms of surfaces obtained with diffe