Adaptive Sliding Mode Control Anticipating Proportional Degradation of Actuator Torque in Uncertain Serial Industrial Robots

• Published in: Symmetry (Basel) 2022-05, Vol.14 (5), p.957
• Main Authors: Truc, Le Ngoc, Vu, Le Anh, Thoan, Tran Van, Thanh, Bui Trung, Nguyen, Tung Lam
• Format: Article
• Language: English
• Subjects: Actuation; actuator failure; actuator torque degradation; Actuators; Adaptation; adaptation control; Adaptive control; Control methods; Control systems design; Control theory; Controllers; Degradation; Failure; Fault tolerance; industrial robot manipulator; Industrial robots; Investigations; Mathematical models; Parameter uncertainty; Robotics; Robots; Servomotors; Simulation; Sliding mode control; Stability criteria; Symmetry; Systems stability; Torque; Upper bounds; Wind power
• ISSN: 2073-8994; 2073-8994
• DOI: 10.3390/sym14050957

The paper focuses on faulty actuator problems in an industrial robot using servomotors, and provides an adaptive sliding mode control law to overcome this circumstance. Because of multifarious reasons, robot actuators can undergo a variety of failures, such as locked or stuck joints, free-swinging joints, and partial or total loss of actuation effectiveness. The robot behavior will become worsen if the system controller has not been designed with adequate faulty tolerance. The proportional degradation of actuator torque at unknown degrees of loss, which is one type of partial loss of actuation effectiveness, is considered in this study to design a suitable controller. The robot model is constructed with uncertain parameters and unknown friction, whereas the controller uses only the approximate parameters. Symmetry and skew-symmetry give important contributions in robot modeling and transformation, as well as in the process of proving the system stability. An adjustable coefficient vector of the proposed controller can adaptively reach the upper bounds of an uncertain parametric vector, which guarantees the criterion of Lyapunov stability. In the numerical simulation stage, the selected industrial robot is a Serpent 1 robot with three degrees of freedom. A quasi-physical model based on MATLAB/Simscape Multibody for the robot is built and used in order to increase the reliability of the simulation performance closer to reality. Simulation results illustrate the efficiency of the proposal control methodology in the presence of the mentioned failure. The controller can still deliver satisfactory responses to the robot system under reasonable levels of actuator torque degradation.