Temperature and strain rate influence on AA5086 Forming Limit Curves: Experimental results and discussion on the validity of the M-K model

• Published in: International journal of mechanical sciences 2014-01, Vol.78, p.27-34
• Main Authors: Chu, Xingrong, Leotoing, Lionel, Guines, Dominique, Ragneau, Eric
• Format: Article
• Language: English
• Subjects: Alloys; Aluminum alloys; Aluminum base alloys; Calibration; Engineering Sciences; Finite element method; Formability; Forming Limit Curves (FLCs); M-K model; Marciniak test; Mathematical analysis; Mathematical models; Mechanics; Mechanics of materials; Physics; Sheet metal; Strain rate
• ISSN: 0020-7403; 1879-2162
• DOI: 10.1016/j.ijmecsci.2013.11.002

Due to the high-strength to weigh ratio, corrosion resistance, good workability and weldability characteristics, aluminum alloys are increasingly used in many sectors. Researches on formability of aluminum alloy sheets have always been a hot topic these last few years while very few works taking into both temperature and strain rate effects on formability limits can be found in the literature. In this study, the formability of sheet metal AA5086 is investigated at different temperatures (20, 150 and 200°C) and strain rates (0.02, 0.2 and 2s−1) through a Marciniak test setup. Experimental results show that the formability of AA5086 increases with temperature and decreases with forming speed. Based on the analytical M-K theory, a Finite Element (FE) M-K model is proposed to predict the Forming Limit Curves (FLCs). A modified Ludwick hardening law with temperature and strain rate functions is proposed to describe the thermo-elasto-viscoplastic behavior of the material. The influence of the initial imperfection (f0) sensitivity in the FE M-K model is discussed and a strategy to calibrate f0 is proposed. The agreement between experimental and numerical FLCs indicates that the FE M-K model can be an effective model for predicting sheet metal formability under different operating conditions if the initial imperfection value is calibrated for each forming condition. •The formability of sheet metal AA5086 is investigated at different temperatures (20–200°C) and strain rates (0.02–2s−1).•The formability is improved with increasing temperature and decreasing strain rate.•The experimental point from the plane strain path permits a good calibration of the FE M-K model.•The calibrated values of the geometrical imperfection vary with the forming conditions.