Optimized design and fabrication of a microfluidic platform to study single cells and multicellular aggregates in 3D

• Published in: Microfluidics and nanofluidics 2017-02, Vol.21 (2), p.1, Article 29
• Main Authors: Marasso, S. L., Puliafito, A., Mombello, D., Benetto, S., Primo, L., Bussolino, F., Pirri, C. F., Cocuzza, M.
• Format: Article
• Language: English
• Subjects: Analytical Chemistry; Biomedical Engineering and Bioengineering; Bioreactors; Culture media; Design; Engineering; Engineering Fluid Dynamics; Fabrication; Microscopy; Nanotechnology and Microengineering; Research Paper
• ISSN: 1613-4982; 1613-4990
• DOI: 10.1007/s10404-017-1872-0

A microfluidic platform for cell motility analysis in a three-dimensional environment is presented. The microfluidic device is designed to study migration of both single cells and cell spheroids, in particular under spatially and temporally controlled chemical stimuli. A layout based on a central microchannel confined by micropillars and two lateral reservoirs was selected as the most effective. The microfluidics have an internal height of 350 μm to accommodate cell spheroids of a considerable size. The chip is fabricated using well-established micromachining techniques, by obtaining the polydimethylsiloxane replica from a Si/SU-8 master. The chip is then bonded on a 170-μm-thick microscope glass slide to allow high spatial resolution live microscopy. In order to allow the cost-effective and highly repeatable production of chips with high aspect ratio (5:1) micropillars, specific design and fabrication processes were optimized. This design permits spatial confinement of the gel where cells are grown, the creation of a stable gel–liquid interface and the formation of a diffusive gradient of a chemoattractant (>48 h). The chip accomplishes both the tasks of a microfluidic bioreactor system and a cell analysis platform avoiding critical handling of the sample. The experimental fluidic tests confirm the easy handling of the chip and in particular the effectiveness of the micropillars to separate the Matrigel™ from the culture media. Experimental tests of (i) the stability of the gradient, (ii) the biocompatibility and (iii) the suitability for microscopy are presented.