Fixed, object-specific intensity compensation for cone beam optical CT radiation dosimetry

• Published in: Physics in medicine & biology 2018-03, Vol.63 (6), p.06NT02-06NT02
• Main Authors: Dekker, Kurtis H, Hazarika, Rubin, Silveira, Matheus A, Jordan, Kevin J
• Format: Article
• Language: English
• Subjects: 3D radiation dosimetry; cone beam CT; optical CT; source compensator
• ISSN: 0031-9155; 1361-6560; 1361-6560
• DOI: 10.1088/1361-6560/aab17f

Optical cone beam computed tomography (CT) scanning of radiochromic gel dosimeters, using a CCD camera and a low stray light convergent source, provides fast, truly 3D radiation dosimetry with high accuracy. However, a key limiting factor in radiochromic gel dosimetry at large ( 10 cm diameter) volumes is the initial attenuation of the dosimeters. It is not unusual to observe a 5-10×  difference in signal intensity through the dosimeter center versus through the surrounding medium in pre-irradiation images. Thus, all dosimetric information in a typical experiment is measured within the lower 10%-20% of the camera sensor's range, and re-use of gels is often not possible due to a lack of transmission. To counteract this, in this note we describe a simple method to create source compensators by printing on transparent films. This technique, which is easily implemented and inexpensive, is an optical analogue to the bowtie filter in x-ray CT. We present transmission images and solution phantom reconstructions to demonstrate that (1) placing compensators beyond the focal zone of the imaging lens prevents high spatial frequency features of the printed films from generating reconstruction artifacts, and (2) object-specific compensation considerably reduces the range of intensities measured in projection images. This will improve the measurable dose range in optical CT dosimetry, and will enable imaging of larger gel volumes ( 15 cm diameter). Additionally, it should enable re-use of dosimeters by printing a new compensator for a second experiment.