Strain rate dependency of bovine trabecular bone under impact loading at sideways fall velocity

• Published in: Journal of biomechanics 2018-06, Vol.75, p.46-52
• Main Authors: Enns-Bray, William S., Ferguson, Stephen J., Helgason, Benedikt
• Format: Article
• Language: English
• Subjects: Accidental Falls; Animals; Anisotropy; Bone marrow; Bone strength; Bulk density; Cancellous bone; Cancellous Bone - physiology; Cattle; Compression; Compression tests; Computer simulation; Dependence; Drop tower; Drop towers; Elastic Modulus; Experiment; Experiments; Femur; Femur - diagnostic imaging; Femur - physiology; Finite Element Analysis; Finite element method; Hip; Hip - physiology; Impact; Impact loads; Impact tests; Kinetic energy; Material properties; Mathematical models; Mechanical loading; Mechanical Phenomena; Mechanical properties; Mechanics; Modulus of elasticity; Morphology; Piezoelectricity; Porous materials; Regression analysis; Regression models; Strain rate; Stress, Mechanical; Tensile stress; Tibia - diagnostic imaging; Tibia - physiology; Trabecular bone; Video compression; X-Ray Microtomography
• ISSN: 0021-9290; 1873-2380
• DOI: 10.1016/j.jbiomech.2018.04.042

There is currently a knowledge gap in scientific literature concerning the strain rate dependent properties of trabecular bone at intermediate strain rates. Meanwhile, strain rates between 10 and 200/s have been observed in previous dynamic finite element models of the proximal femur loaded at realistic sideways fall speeds. This study aimed to quantify the effect of strain rate (ε̇) on modulus of elasticity (E), ultimate stress (σu), failure energy (Uf), and minimum stress (σm) of trabecular bone in order to improve the biofidelity of material properties used in dynamic simulations of sideways fall loading on the hip. Cylindrical cores of trabecular bone (D = 8 mm, Lgauge = 16 mm, n = 34) from bovine proximal tibiae and distal femurs were scanned in µCT (10 µm), quantifying apparent density (ρapp) and degree of anisotropy (DA), and subsequently impacted within a miniature drop tower. Force of impact was measured using a piezoelectric load cell (400 kHz), while displacement during compression was measured from high speed video (50,000 frames/s). Four groups, with similar density distributions, were loaded at different impact velocities (0.84, 1.33, 1.75, and 2.16 m/s) with constant kinetic energy (0.4 J) by adjusting the impact mass. The mean strain rates of each group were significantly different (p