The influence of temperature on the physicochemical properties of products of pyrolysis of leather-tannery waste

• Published in: Waste management (Elmsford) 2019-04, Vol.88, p.248-256
• Main Authors: Kluska, Jacek, Ochnio, Mateusz, Kardaś, Dariusz, Heda, Łukasz
• Format: Article
• Language: English
• Subjects: Gases; Hot Temperature; Pyrolysis; Tannery waste; Temperature; Thermogravimetric analysis; Waste Products
• ISSN: 0956-053X; 1879-2456
• DOI: 10.1016/j.wasman.2019.03.046

•Thermal decomposition of leather waste begins at 80 °C and maximum occurs at 325 °C.•Technical analysis showed that leather wastes are similar to poultry-derived wastes.•Pyrolysis of leather wastes for energetic application makes sense above 400–450 °C. The present paper examines the pyrolysis of waste from leather tanneries at 300–500 °C. These studies are important because of difficulties in the utilisation of this type of waste as well as its energy potential as fuel. The pyrolysis of tannery waste and data from the relevant literature showed that thermal degradation can be explained using tanned collagen as a reference. Moreover, the experimental results indicated that this process is highly non-linear, due to various mechanisms of heat transport which cause temperature differences in a laboratory pyrolysis reactor. Thermogravimetric analysis has shown that the greater part of mass loss is observed between 80 and 500 °C and that the most significant mass release occurs at 325 °C. Moreover, the proportions of CO2 and CO decrease along with increasing temperatures. The paper presents characteristics of the composition of solid, liquid, and gaseous products of leather-waste pyrolysis at various temperatures. The maximum heating value of gaseous products at 500 °C was 9.54 MJ/Nm3. An increase from 300 to 500 °C results in the dominant position of condensation polymerisation; the maximum value of the liquid phase yield is reached at 400 °C (42%). HHV analysis of the resulting char showed a maximum value of 21.18 MJ/kg at 450 °C. The results of oxidised component analysis showed that the major oxidised component of char was chromium oxide (Cr2O3), with a content of approximately 8.5% at all pyrolysis temperatures.