A shell/3D modeling technique for the analysis of delaminated composite laminates

• Published in: Composites. Part A, Applied science and manufacturing Applied science and manufacturing, 2001, Vol.32 (1), p.25-44
• Main Authors: Krueger, R, O'Brien, T.K
• Format: Article
• Language: English
• Subjects: Applied sciences; C. Finite element analysis; Composite materials; Exact sciences and technology; Forms of application and semi-finished materials; Laminates; Polymer industry, paints, wood; Technology of polymers
• ISSN: 1359-835X; 1878-5840
• DOI: 10.1016/S1359-835X(00)00133-0

A shell/3D modeling technique was developed for which a local three-dimensional solid finite element model is used only in the immediate vicinity of the delamination front. The goal was to combine the accuracy of the full three-dimensional solution with the computational efficiency of a plate or shell finite element model. Multi-point constraints provided a kinematically compatible interface between the local three-dimensional model and the global structural model which has been meshed with plate or shell finite elements. Double cantilever beam (DCB), end notched flexure (ENF), and single leg bending (SLB) specimens were modeled using the shell/3D technique to study the feasibility for pure mode I (DCB), mode II (ENF) and mixed mode I/II (SLB) cases. Mixed mode strain energy release rate distributions were computed across the width of the specimens using the virtual crack closure technique. Specimens with a unidirectional layup and with a multidirectional layup where the delamination is located between two non-zero degree plies were simulated. For a local three-dimensional model, extending to a minimum of about three specimen thicknesses on either side of the delamination front, the results were in good agreement with mixed mode strain energy release rates obtained from computations where the entire specimen had been modeled with solid elements. For large built-up composite structures modeled with plate elements, the shell/3D modeling technique offers a great potential for reducing the model size, since only a relatively small section in the vicinity of the delamination front needs to be modeled with solid elements.