Surface Defect Engineering of a Bimetallic Oxide Precatalyst Enables Kinetics-Enhanced Lithium–Sulfur Batteries

• Published in: ACS applied materials & interfaces 2022-11, Vol.14 (44), p.49680-49688
• Main Authors: Zhao, Gang, Kao, Cheng-Wei, Gu, Zhonghao, Zhou, Shaohui, Chang, Lo-Yueh, Yan, Tianran, Cheng, Chen, Yuan, Cheng, Li, Hongtai, Chan, Ting-Shan, Zhang, Liang
• Format: Article
• Language: English
• Subjects: Energy, Environmental, and Catalysis Applications
• ISSN: 1944-8244; 1944-8252
• DOI: 10.1021/acsami.2c12507

Developing efficient electrocatalysts to accelerate the sluggish conversion of lithium polysulfides (LiPSs) is of paramount importance for improving the performances of lithium–sulfur (Li–S) batteries. However, a consensus has not yet been reached on the in situ evolution of the electrocatalysts as well as the real catalytic active sites. Herein, defective MnV2O6 (D-MVO) is designed as a precatalyst toward LiPSs’ adsorption and conversion. We reveal that the introduction of surface V defects can effectively accelerate the in situ sulfurization of D-MVO during the electrochemical cycling process, which acts as the real electrocatalyst for LiPSs’ retention and catalysis. The in situ-sulfurized D-MVO demonstrates much higher electrocatalytic activity than the defect-free MVO toward LiPSs’ redox conversion. With these merits, the Li–S batteries with D-MVO separators achieve superior long-term cycling performance with a low decay rate of 0.056% per cycle after 1000 cycles at 1C. Even under an elevated sulfur loading of 5.5 mg cm–2, a high areal capacity of 4.21 mAh cm–2 is still retained after 50 cycles at 0.1C. This work deepens the cognition of the dynamic evolution of the electrocatalysts and provides a favorable strategy for designing efficient precatalysts for advanced Li–S batteries using defect engineering.