Evaluation of the fracture toughness properties of polytetrafluoroethylene

• Published in: International journal of fracture 2004-06, Vol.127 (4), p.361-385
• Main Authors: JOYCE, Peter J, JOYCE, James A
• Format: Article
• Language: English
• Subjects: Aluminum; Coefficient of friction; Diaphragms; Ductile fracture; Ductile-brittle transition; Exact sciences and technology; Fracture mechanics (crack, fatigue, damage...); Fracture toughness; Fundamental areas of phenomenology (including applications); Gaskets; Heat treating; Inelasticity (thermoplasticity, viscoplasticity...); Physics; Piston rings; Polymers; Polytetrafluoroethylene; Projectiles; Properties (attributes); Solid mechanics; Structural and continuum mechanics
• ISSN: 0376-9429; 1573-2673
• DOI: 10.1023/B:FRAC.0000037674.46965.fb

Polytetrafluoroethylene (PTFE) (Dupont Tradename Teflon) is a common polymer with many structural applications including sheet, gaskets, bearing pads, piston rings and diaphragms. The interest here developed because this polymer is being considered as the major component of a newly proposed 'reactive' material with a possible application as a projectile to replace common inertial projectiles. Little mechanical property data is available on this material since it is commonly used only as a coating material with the dominant properties being its low friction coefficient and high application temperature. Previous work (Joyce, 2003) on commercially available sheet PTFE material has demonstrated the applicability of the normalization method of ASTM E1820 (1999), the elastic-plastic fracture toughness standard to develop fracture toughness properties of this material over a range of test temperatures and loading rates. Additional work on the aluminum filled 'reactive' derivative of the basic PTFE polymer (Joyce and Joyce, 2004) has also recently been completed. In this work, standard ASTM E1820 fracture toughness specimens machined from sintered pucks of PTFE were tested at four test temperatures and at a range of test rates to determine the J1, and J resistance curve characteristics of the PTFE material. The major results are that while crack extension is difficult at standard laboratory loading rates at ambient (21 DGC) temperature or above, for temperatures slightly below ambient or for elevated loading rates, a rapid degradation of fracture resistance occurs and cracking occurs in a ductile or even nearly brittle manner.