Reaction of citric acid with calcite

• Published in: Chemical engineering science 2007-11, Vol.62 (21), p.5880-5896
• Main Authors: Al-Khaldi, M.H., Nasr-El-Din, H.A., Mehta, S., Al-Aamri, A.D.
• Format: Article
• Language: English
• Subjects: Applied sciences; Calcium citrate; Chemical engineering; Citric acid; Dissolution rate; Exact sciences and technology; Heat and mass transfer. Packings, plates; Rotating disk
• ISSN: 0009-2509; 1873-4405
• DOI: 10.1016/j.ces.2007.06.021

The reaction of citric acid with calcite was investigated using the rotating disk apparatus. The effects of disk rotational speed, system pressure, and presence of magnesium and ferric ions on this reaction were examined. Scanning electron microscope (SEM) was also used to characterize the surface of the calcite disks at the end of each experiment. The reaction of citric acid and calcite is mass-transfer limited up to 500 rpm. The reaction rate of citric acid–calcite is limited by the precipitation of calcium citrate on the surface, especially at atmospheric pressure. Increasing the system pressure from 1000 to 1500 psi has no significant effect on the dissolution rate of calcite. The diffusion coefficient of 7.5 wt% citric acid in the presence of calcium citrate and calcium ions is 4.5 E - 6 cm 2 / s at 50 ∘ C and 1000 psi. The presence of magnesium ions in citric acid solutions results in higher concentration of calcium ions in solution. Calcium citrate forms only on the disk surface, but not in the bulk solution. The morphology of the calcium citrate layer is dependent on the rotational speed of the calcite disk. More calcium citrate precipitation occurs at high disk rotational speeds, above 500 rpm, and at system pressures less than 100 psi. Calcium citrate appears to precipitate as feathery aggregates of radiating platy crystals on the surface of calcite.