The Fabrication and Characterization of BaTiO 3 Piezoceramics Using SLA 3D Printing at 465 nm Wavelength

• Published in: Materials 2022-01, Vol.15 (3)
• Main Authors: Smirnov, Andrey, Chugunov, Svyatoslav, Kholodkova, Anastasia, Isachenkov, Maxim, Tikhonov, Andrey, Dubinin, Oleg, Shishkovsky, Igor
• Format: Article
• Language: English
• ISSN: 1996-1944; 1996-1944

The additive manufacturing of BaTiO (BT) ceramics through stereolithography (SLA) 3D printing at 465 nm wavelength was demonstrated. After different milling times, different paste compositions with varied initial micron-sized powders were studied to find a composition suitable for 3D printing. The pastes were evaluated in terms of photopolymerization depth depending on the laser scanning speed. Furthermore, the microstructure and properties of the BT ceramic samples produced through SLA 3D printing were characterized and compared with those of ceramics fabricated through a conventional die semi-drying pressing method. Three-dimensional printed samples achieved relative densities over 0.95 and microhardness over 500 HV after sintering, nearly matching the relative density and microhardness attained by the pressed samples. Upon poling, the 3D-printed samples attained acceptable piezoelectric module d = 148 pC/N and dielectric constants over 2000. At near full density, BT piezoceramics were successfully fabricated through SLA 3D printing at 465 nm wavelength, achieving photopolymerization depth of more than 100 microns. This work paves the relatively low-cost way for 3D printing of piezoelectric ceramics using conventional micron-sized powders and high printed layer thickness.